how to change port for faxrunq?

• Messages sorted by:[ date ][ thread ][ subject ][ author ]

Hi,

write the line

"fax-devices ttyS0:ttyS1:ttyWHATEVER"

into "sendfax.config". This is what gets used if faxrunq runs.

gert

Diana Eichert wrote:
> I am having a problem getting faxrunq to run properly. After I ran=20
> faxspool xxx-yyyy di.g3 I then ran faxrunq.
>=20
> >><ts>=02 /home/fax # faxrunq
> >>processing F000001.25524/JOB...
> >>/usr/local/sbin/sendfax -v xxx-yyyy f1.g3
> >>Trying fax device '/dev/tty4c'... cannot open!
> >>Trying fax device '/dev/tty4d'... cannot open!
> >>/usr/local/sbin/sendfax: cannot access fax device(s) (locked?)
> >>command exited with status 2
>=20
> I know how to invoke correct port(s) using sendfax directly, how do you=
=20
> inform faxrunq to use different port(s)?  I've looked in the FAQ and=20
> Hypertext manual, and the man pages, couldn't find solution.
>=20
> Did I miss something somewhere?
>=20
> thanks again for software,
>=20
> Diana Eichert
> deichert@wrench.com
>=20
>=20


--=20
USENET is *not* the non-clickable part of WWW!
                                                           //www.muc.de/~ge=
rt/
Gert Doering - Munich, Germany                             gert@greenie.muc=
.de
fax: +49-89-3545980                         gert.doering@physik.tu-muenchen=
.de