cannot get TIO

• Messages sorted by:[ date ][ thread ][ subject ][ author ]

Hi,
  I am sure this has been addressed before but I have searched just about
everywhere I can think of trying to figure out what I would need to do to
get rid of the cannot get TIO error I receive from time to time. Apparently
it doesn't seem to hurt anything because it just reports it and the next
time it seems to work just fine but I thought I would ask. I run Slackware
3.4 with kernel 2.0.33 and have an 8 port Cyclades board in which I have 8
modems attached to it to provide ppp access to the Internet, as you can tell
I am using the newest release of mgetty, the modems I have are just standard
modems, 4 generic (no name) 28.8 and 4 InfoTel 14.4's. Any feedback would be
greatly appreciated and once again sorry if this had been addressed in the
past.

Here is a sample from my logfile.


04/09 01:38:05 yC1  mgetty: experimental test release 1.1.14-Apr02
04/09 01:38:05 yC1  check for lockfiles
04/09 01:38:05 yC1  locking the line
04/09 01:38:06 yC1  WARNING: DCD line still active, check modem settings (AT&Dx)
04/09 01:38:06 yC1  lowering DTR to reset Modem
04/09 01:38:06 yC1  TIOCMBIS failed: I/O error
04/09 01:38:06 yC1  cannot turn off soft carrier: I/O error
04/09 01:38:06 yC1  tcgetattr failed: I/O error
04/09 01:38:06 yC1  cannot get TIO: I/O error
04/09 01:38:06 yC1  mg_init_device failed, trying again
04/09 01:38:06 yC1  lowering DTR to reset Modem
04/09 01:38:07 yC1  send: \d+++\dAT&F&C1&D2&R1[0d]
04/09 01:38:08 yC1  waiting for `OK'' ** found **
04/09 01:38:08 yC1  send: ATsM0sE0sQ0sV1sX4[0d]
04/09 01:38:08 yC1  waiting for `OK'' ** found **
04/09 01:38:09 yC1  waiting...
04/09 01:38:28 yC1  waiting for `RING'' ** found **
04/09 01:38:28 yC1  send: ATA[0d]
04/09 01:38:28 yC1  waiting for `CONNECT'' ** found **
04/09 01:38:41 yC1  send: 
04/09 01:38:41 yC1  waiting for `_'' ** found **
04/09 01:38:44 ##### data dev=ttyC1, pid=8330, caller='none',
conn='38400/ARQ/26400 LAP-M', name='', cmd='/usr/sbin/pppd', user='/AutoPPP/'

odd that a 28.8 only connects at 26.4 each time but I have never seen any
modem connect any higher on this campus.

TIA

Eric