Problem while trying fax-poling

• Messages sorted by:[ date ][ thread ][ subject ][ author ]

Hi Gert,

> > 04/30 15:30:56 yS1  fax_send: 'AT%TCBDT06966983832'
> What on earth is *that*? AT%TCB?

If you try to initiate a call within 30 seconds after a failed/the last
call the modem wont do so, (german: Wahlsperre)... It's a work around...
Other modems use other ways...

> > 04/30 15:31:12 yS1   fax_wait_for: string 'OK'** found **
> > 04/30 15:31:12 yS1   sendfax: honouring DCD (carrier) drops now
> > 04/30 15:31:12 yS1   tio_set_flow_control( HARD XON_IN )
> > 04/30 15:31:12 yS1  fax_send: 'AT+FDR'
> > 04/30 15:31:12 yS1  fax_wait_for(CONNECT)
> > 04/30 15:31:12 yS1   fax_wait_for: string 'AT+FDR'

the last line is the problem...
sendfax hangs after this line and waits... the hangup of the modem comes
later...

> > 04/30 15:33:12 yS1  Warning: got alarm signal!
> > 04/30 15:33:12 yS1  mdm_read_byte: read returned -1: Interrupted system call
> > 04/30 15:33:12 yS1  mdm_get_line: cannot read byte, return: Interrupted system call
> Try setting "ignore-carrier yes" in sendfax.config.  This *might* help.
> If it still doesn't help, there is nothing you can do except get a newer
> firmware version from the manufacturer.

Damn (sorry), that doesnt help...

> Most modem manufacturers just don't care, this is the problem.

I'm currently getting a new firmware.. lets try..
I'll write you a mail after that... (wish me good luck ;-) )

Cu, Ronny

(Sorry about my bad english)