Problem with 5600zdxv modem and voice

• Messages sorted by:[ date ][ thread ][ subject ][ author ]

I've been looking into vgetty source code to find out why my 5600ZDXV
modem does not get detected, and figured that it was because of the ATI
response code *not* being inside the libvoice/detect.c code.....

Well, further hunting discovered that this modem uses the #V command set
to control voice operation, whereas ALL the other modems appear to be
making use of the +V command set.

Does someone know if I can get this multitech going?  Has anyone done
this - or am I stuck with sending this thing BACK to the supplier
(please don't make me do this)???  I've looked at the #V and +V command
documentation from multitech and it looks different enough to pose a
problem ....

Did #V come out first, or was it a 'cheapo' replacement protocol for the
+V set?

Regards

--
=======================================================================
John Clayton
=======================================================================