Banksia MyVoice modems

• Messages sorted by:[ date ][ thread ][ subject ][ author ]

Hi,

On Sat, May 15, 1999 at 11:24:20PM +1000, Simon Butcher wrote:
>  One problem; Vgetty returns a ton of errors, stating the modem is not a
> voice modem, and one further problem has arisen when I was going to try and
> manually initialise the modem into voice modem - there's no documentation on
> the modem's voice commands! Banksia's website is chockas with fax/data
> attention commands, but there's nothing about voice.

Well, it's pretty much up to you now - find out from the manufacturer
about the exact command set used, then send us that and the output of 
all the ATI codes (ATI, ATI1, ATI2, ..., ATI9, not just ATI3 and ATI6) 
and we can add support for it to vgetty.  Or, alternatively, you can do
that yourself...

[..]
>  I'm not an expert, but I know what annoys me. Did someone decide it would
> be better to hide these commands while all over modem manufacturers release
> them freely?

Most modem manufacturers don't document them properly and need some
prodding until they release proper documentation.

Gone are the times where modem manuals contained full documentation for
every single command...

gert
-- 
USENET is *not* the non-clickable part of WWW!
                                                           //www.muc.de/~gert/
Gert Doering - Munich, Germany                             gert@greenie.muc.de
fax: +49-89-35655025                        gert.doering@physik.tu-muenchen.de