Modems hanging up

• Messages sorted by:[ date ][ thread ][ subject ][ author ]

I tried the at&v (which is not documented in the manual) and got;

OK
at&v

    Option               Selection       AT Cmd
    ---------------      ------------    --------
    Comm Standard        Bell            B
    CommandCharEcho      Enabled         E
    Speaker Volume       Medium          L
    Speaker Control      Off             M
    Result Codes         Enabled         Q
    Dialer Type          Tone            T/P
    ResultCode Form      Text            V
    ExtendResultCode     Enabled         X
    DialTone Detect      Enabled         X
    BusyTone Detect      Enabled         X
    CDC Action           Standard RS232  &C
    DTR Action           Off=Reset       &D
Press any key to continue; ESC to quit.          


    Option               Selection       AT Cmd
    ---------------      ------------    --------
    V22b Guard Tone      Disabled        &G
    Flow Control         Hardware        &K
    Error Control Mode   V42,MNP,Buffer  \N
    Data Compression     Enabled         %C
    AutoAnswerRing#      0               S0
    AT Escape Char       43              S2
    CarriageReturn Char  13              S3
    Linefeed Char        10              S4
    Backspace Char       8               S5
    Blind Dial Pause     2 sec           S6
    NoAnswer Timeout     50 sec          S7
    "," Pause Time       2 sec           S8
Press any key to continue; ESC to quit.      

    Option               Selection       AT Cmd
    ---------------      ------------    --------
    No Carrier Disc      2000 msec       S10
    DTMF Dial Speed      95 msec         S11
    Escape GuardTime     1000 msec       S12
    Data Calling Tone    Disabled        S35
    Line Rate            33600           S37
Press any key to continue; ESC to quit.         

    Stored Phone Numbers
    --------------------
     &Z0=
     &Z1=
     &Z2=
     &Z3=

OK

Some of these codes aren't even documented in the manual.
Probably another good reason for getting rid of the old ones.


-greg